全国服务热线:15953195999
产品中心
您所在的位置:首页-新闻中心-常见问题-叉车行驶过程中的注意事项有哪些?

叉车行驶过程中的注意事项有哪些?

来源:http://www.chinesefoodpicture.com/ 日期:2022-02-08 发布人:hangong

叉车在行驶过程中需注意以下几点:

The forklift shall pay attention to the following points during driving:
1.行驶时,货叉底端距地高度应保持300~400mm,门架须后倾。
1. When driving, the height from the bottom of the fork to the ground shall be maintained at 300 ~ 400mm, and the gantry must be tilted back.
2.行驶时不得将货叉升得太高。叉车租赁公司表示进出作业现场或行驶途中,要注意上空有无障阻物刮碰。载物行驶时,货叉不准升得太高,影响叉车的稳定性。
2. Do not raise the fork too high when driving. The forklift leasing company said that when entering and leaving the operation site or driving, pay attention to whether there are obstacles in the air. When the load is driving, the fork shall not be raised too high, which will affect the stability of the forklift.
3.卸货后应先降落货叉至正常的行驶位置后再行驶。
3. After unloading, lower the fork to the normal driving position before driving.
4.转弯时,如附近有行人或车辆,应先发出行驶信号。禁止高速急转弯,高速急转弯会导致车辆失去横向稳定而倾翻。
4. When turning, if there are pedestrians or vehicles nearby, send out the driving signal first. It is forbidden to turn sharply at high speed, which will cause the vehicle to lose lateral stability and overturn.
5.行驶叉车在下坡时严禁熄火滑行,非特殊情况禁止载物行驶中急刹车。
5. It is strictly forbidden to stop the forklift when it goes downhill, and it is forbidden to brake suddenly when it is driving with load except under special circumstances.
6.叉车在运行时要遵守厂内交通规则,需要与前面的车辆保持一定的距离。
6. The forklift shall comply with the traffic rules in the factory and keep a certain distance from the vehicle in front.
7.叉车租赁公司表示叉车运行时,载荷需要处于不妨碍行驶的低位置,门架要适当后倾。除堆垛或装车时,不得升高载荷。
7. The forklift leasing company said that when the forklift is running, the load needs to be in a low position that does not hinder driving, and the gantry should be tilted back properly. The load shall not be lifted or removed during stacking.
8.载物高度不得遮挡驾驶员视线。特殊情况物品影响前行视线时,倒车时要低速行驶
8. The height of the load shall not block the driver's line of sight. Under special circumstances, when objects affect the line of sight of the front line, drive at a low speed when reversing
9.禁止在坡道上转弯,也不应横跨坡道行驶。
9. It is forbidden to turn on the ramp or drive across the ramp.
10.叉车厂区行驶速度5公里/小时,进入生产车间区域需要低速行驶。
10. The traveling speed of forklift truck in the plant area is 5km / h, and it needs to drive at a low speed to enter the production workshop area.
11.叉车的起重升降或行驶时,禁止人员站在货叉上把持物品和起平衡作用。
11. During the lifting, lifting or driving of forklift, it is forbidden for personnel to stand on the fork to hold objects and balance.
12.叉车租赁公司表示发现问题及时检修和上报,不带病作业和隐瞒不报。
12. The forklift leasing company said that it should repair and report problems in time, and do not operate with diseases or hide them.

济南韩工机械设备有限公司
地址:山东省济南市章丘区龙山街道济青路龙山段南侧1幢   电话:15953195999
网站:http://www.chinesefoodpicture.com/   备案号:鲁ICP备14018186号-1  技术支持:网站建设·推广运营

鲁公网安备 37011202000702号

 

【本站图片均由网站所有方提供,部分图片来源于网络,如无意中侵犯了某媒体或个人的知识产权,请来信或来电告之,本网站将立即删除?!?/p>